Locate gas supply valve (typically behind louvers, 
below glass opening - may be red or blue).

Open valve by pivoting handle to be parallel to gas 
line.

Locate pilot assembly with spark ignitor (located 
behind and below logs in the firebox - typically in the bottom center).

Then locate red or black ignitor button.*  Push ignitor 
to verify spark at pilot area.
 

Locate the black or green valve control knob (knob 
with the words "ON", "OFF" and "PILOT" on it).  
Push in and rotate counter-clockwise until the word "pilot" is in the 6 o'clock position.**

While pressing and holding in the valve knob (in "PILOT" position - it should press in about 1/4"), press the red piezo button repeatedly (once per second) until the pilot ignites.  If the pilot does not light, wait 5 minutes and try again.  Once the pilot is lit, continue to hold the valve knob in for 30 seconds, then slowly release.

If the pilot light goes out, contact your nearest dealer for service.  Remember to shut the gas supply valve off (picture #1).  If it remains lit, press the valve knob in slightly and rotate counter-clockwise until the word "ON" is in the 6 o'clock position.

Finally, turn the unit's ON/OFF switch (or wall switch 
or remote control) to the "ON" position to start your 
fire.

Make sure you put the glass front back on the fireplace prior to burning your fireplace. Make sure the glass is securely clamped on, at all points, prior to replacing the front

Enjoy your fireplace!